Tel: 86-0631-5769571
Fax: 86-0631-5769561
E-Mail:
abigale1314@126.com
abigale1314@yahoo.cn
MSN:
abigale_1983@hotmail.
If the joints are fixed too tightly
■ Extension rod
The main cause of the joints fixed too tightly is extending the rod too forcibly. When the joints are fixed too tightly, hold the anti-sliding place near joints, screw and press them in reverse direction to loosen the joints. Pay attention not to press too forcibly, which may hurt your hands.
■ Insertion rod
Hold the anti-sliding place near rubber seat or rubber wheel near joints, and screw and pull them in reserve direction in order to loosen the joints.
■ Extension rod without guide
Remove the plug of B section, pull out the fixed two sections. Then put the rod vertically on a not-too-hard plain ground (or put towel or other soft material on the ground), hold the fixed joints and knock the ground.
Address:Yangting industrial area, Zhangcun town, Weihai, Shangdong province, China.